Monitor Lamp Indicators; Managing The Indicated Problems - Panasonic PTDZ8700U - DLP PROJECTOR Operating Instructions Manual

Monitor Lamp indicators

Managing the indicated problems

If a problem should occur with the projector, the indicators will inform you. Manage the indicated problems as
follow.
Attention
Power indicator
(STANDBY (R) / ON (G))
J
LAMP1/LAMP2 indicator
Lamp
Information
indication
Indicates the time
Lighting in red for replacing the
lamp unit.
Blinking in red Lamp unit is not
(once) installed.
Blinking in red Error is detected
(3 times) in the lamp circuit.
Note
z
If no problem is found or the problem remains, do not turn on the projector. Instead contact your dealer.
Check point
z
Did you notice a "REPLACE
LAMP" message on the screen
when turning on the projector
power supply?
z
Check the lamp unit
compartment.
z
Did you turn the power back
on immediately after turning it
off?
z
Some error has arisen in the
lamp circuit.
Check for fluctuation (or drop)
z
in the source voltage.
Lamp1 indicator (LAMP1)
Lamp2 indicator (LAMP2)
Temperature indicator (TEMP)
Filter indicator (FILTER)
Remedial measure
z
This lamp monitor lights up when the
lamp unit used hours have reached
2 800 hours (when [HIGH] is selected
as the [LAMP POWER] setting).
z
Request the dealer to replace the lamp
unit.
z
Install the lamp unit.
z
When lamp unit is installed and still
having the indicator lights, contact to
the dealer.
z
Wait until the lamp has cooled off, and
then turn on the power.
z
Turn off the MAIN POWER switch
using the procedure on page 40 and
consult the dealer.
107
ENGLISH -