Input Resolution; Clamp Position; Edge Blending - Panasonic PTDZ8700U - DLP PROJECTOR Operating Instructions Manual

ADVANCED MENU

INPUT RESOLUTION

Input resolution adjustment achieves the best image
when the screen flickers or halo is observed around
the contour. Set the values appropriately for the signal
resolution that is being used.
Press ▲▼ to select [INPUT
1 )
RESOLUTION].
2 ) Press <ENTER> button.
z
The [INPUT RESOLUTION] screen will be
displayed.
Press ▲▼ to select [TOTAL DOTS],
3 )
[DISPLAY DOTS], [TOTAL LINES] or
[DISPLAY LINES], and the press ◄►
to adjust it.
z
Each item automatically displays a value in
response to the type of the input signal. If
vertical stripes appear on the screen or the
image is partly missing, increase or decrease
the displayed value while observing the screen
to achieve the optimal value.
Note
z
The vertical stripes will not appear on the all white signal
image.
z
The picture may be distorted during the adjusting
operation, but this is not a fault.
z
The [INPUT RESOLUTION] can be adjusted only when
RGB signal input is applied with RGB1 and RGB2 IN.

CLAMP POSITION

Use the clamp position adjustment to achieve the
optimal value when dark areas of the image are
crushed or displayed in green.
Press ▲▼ to select [CLAMP
1 )
POSITION].
Press ◄► to adjust.
2 )
z
The value changes from 1 to 255.
z
The optimal value for the clamp position
adjustment
If dark areas are crushed :
The optimal value is the point where the dark
area is best improved.
If the dark areas are displayed in green :
The optimal value is the point where the green
areas become black and the crushing effect is
rectified.
Note
z
The [CLAMP POSITION] can be adjusted only when the
RGB signal input is applied with RGB1 and RGB2 IN.
z
The [CLAMP POSITION] may not be adjusted, depending
on the signal.
64
- ENGLISH

EDGE BLENDING

The built-in edge blending feature allows multiple
projector images to be seamlessly overlapped.
Press ▲▼ to select [EDGE
1 )
BLENDING].
Press ◄► to switch [EDGE
2 )
BLENDING].
z
The setting will change as follows each time
◄► is pressed.
OFF
When the multi-screens are not
OFF
going to be used.
When the default linear blending
ON
ramps are sufficient.
When a user-defined blending
ramp is required. These ramps can
be defined and uploaded to the
USER
projector through the RS-232 port.
Consult your dealer for details.
3 ) Press <ENTER> button.
z
The [EDGE BLENDING] screen will be
displayed.
Press ▲▼ to specify the area to be
4 )
adjusted.
z
To blend the top edge:
z
To blend the bottom edge:
[ON].
z
To blend the left edge:
z
To blend the right edge:
Press ◄► to toggle [ON] and [OFF].
5 )
Press ◄► to adjust the overlap width
6 )
and the starting point.
ON USER
set [UPPER] to [ON].
set [LOWER] to
set [LEFT] to [ON].
set [RIGHT] to [ON].