Table of Contents
Related Manuals for Panasonic PT-DZ870K
Summary of Contents for Panasonic PT-DZ870K
- Page 1 PT-DZ870K/DZ870W P ro d u c t N u m b e r : PT-DZ870LK/DZ870LW Projectors ™ P ro d u c t N a m e : As of September 2013. Specifications and appearance are subject to change without notice.
-
Page 2: Specifications
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Specifications Main unit Power supply 120–240 V AC, 10–5.2 A, 50/60 Hz Power consumption 120–240 V AC, 50/60 Hz 1,030 W (1,060 VA) (0.3 W with set to , 3 W with STANDBY MODE set to STANDBY MODE NORMAL DLP™... - Page 3 PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Keystone correction range Vertical ±40° (vertical ±30° with the ET-DLE085/DLE055, vertical +5° with the ET-DLE030) When using only the KEYSTONE correction of the Geometric Adjustment function: Vertical ±40°, horizontal ±15° (vertical ±30° and horizontal ±15° with the ET-DLE085/DLE055) When using the optional upgrade kit ET-UK20* Vertical ±45°...
- Page 4 NOTE: Compatible with non-interlaced signals only. Power cord length 3.0 m (9 ft 10 in) Cabinet materials Molded plastic Dimensions (W × H × D) PT-DZ870K/DZ870W 498 × 200* × 556 mm (19-19/32 × 7-7/8* × 21-7/8 inches) (with supplied lens) PT-DZ870LK/DZ870LW 498 ×...
-
Page 5: Hdmi Input
20% to protect the projector. * 9 Operation range differs depending on environments. Dimensions unit : mm (inch) NOTE: This illustration is not drawn to scale. The illustration shows the PT-DZ870K/DZ870W. 442 (13/32) 432 (17) 498 (19/32) Terminals Remote 1 input... -
Page 6: Standard Setting-Up Position (If Using Other Than The Et-Dle030)
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Standard setting-up position (If using other than the ET-DLE030) *1 When the lens protrudes to the maximum. 84 mm (3-5/16 in) with the ET-DLE085 ø60.5 43 mm (1-11/16 in) with the supplied lens 44 mm (1-23/32 in) with the ET-DLE150... -
Page 7: Projection Distance For 16:10 Aspect Ratio Screen (If Using Other Than The Et-Dle030)
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Projection distance for 16:10 aspect ratio screen (If using other than the ET-DLE030) Unit: meters Screen size Distance to screen (L) Height from the edge of screen to (diagonal) Zoom Fixed-focus center of lens (H) Zoom Fixed- Supplied lens... -
Page 8: Projection Distance For 16:9 Aspect Ratio Screen (If Using Other Than The Et-Dle030)
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Projection distance for 16:9 aspect ratio screen (If using other than the ET-DLE030) Unit: meters Screen size Distance to screen (L) Height from the edge of screen to (diagonal) Zoom Fixed-focus center of lens (H) Zoom Fixed- Supplied lens... -
Page 9: Projection Distance For 4:3 Aspect Ratio Screen (If Using Other Than The Et-Dle030)
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Projection distance for 4:3 aspect ratio screen (If using other than the ET-DLE030) Unit: meters Screen size Distance to screen (L) Height from the edge of screen to (diagonal) Zoom Fixed-focus center of lens (H) Zoom Fixed- Supplied lens... -
Page 10: Standard Setting-Up Position (If Using The Et-Dle030)
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Standard setting-up position (If using the ET-DLE030) *1 When the lens protrudes to the maximum. 84 mm (3-5/16 in) with the ET-DLE085 43 mm (1-11/16 in) with the supplied lens 44 mm (1-23/32 in) with the ET-DLE150 ø60.5... -
Page 11: Projection Distance For 16:10 Aspect Ratio Screen (If Using The Et-Dle030)
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Projection distance for 16:10 aspect ratio screen (If using the ET-DLE030) Unit : meters Ultra-short focal length lens ET-DLE030 Close-up system dimensions Throw ratio 0.38:1 (0.39:1) From front of From rear of From top of set to From bottom of set... -
Page 12: Projection Distance For 16:9 Aspect Ratio Screen (If Using The Et-Dle030)
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Projection distance for 16:9 aspect ratio screen (If using the ET-DLE030) Unit : meters Ultra-short focal length lens ET-DLE030 Close-up system dimensions Throw ratio 0.38:1 (0.4:1) From front of From rear of From top of set to From bottom of set... -
Page 13: Projection Distance For 4:3 Aspect Ratio Screen (If Using The Et-Dle030)
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Projection distance for 4:3 aspect ratio screen (If using the ET-DLE030) Unit : meters Ultra-short focal length lens ET-DLE030 Close-up system dimensions Throw ratio 0.38:1 (0.46:1) From front of From rear of From top of set to From bottom of set... -
Page 14: Calculation Of The Projection Distance
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Calculation of the projection distance For a screen size different from the above, use the equation below to calculate the projection distance. Aspect ratio 16:10 ET-DLE085 minimum L (m) = (diagonal screen size in inches) × 0.0174 - 0.0471 maximum L (m) = (diagonal screen size in inches) ×... -
Page 15: Shift Range
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Formula for calculating possible heights when using the ET-DLE030 If using a screen size which has not been previously mentioned, use the following calculation formulas to obtain the possible setting-up height. For screen aspect ratio of 16:10 Possible setting-up height A1 (mm) = Projection screen size (inches) x 5.0-72.1... -
Page 16: Installable Angle
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Installable angle Install the projector at an angle within the range shown below. • Vertical direction • Horizontal direction The projector may be installed at a vertical The projector may be installed at a horizontal angle of 360°. -
Page 17: List Of Compatible Signals
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector List of compatible signals The signals that can be input to this projector are shown in the table below. Horizontal scanning fre- quencies of 15 kHz to 100 kHz, vertical scanning frequencies of 24 Hz to 120 Hz, and a dot clock of 162 MHz maximum can be input. - Page 18 PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Display mode Display Scanning frequency Dot clock Format resolution frequency (dots)* (kHz) (kHz) (MHz) 1280 × 720 RGB/HDMI/DVI-D 1280 × 720 37.1 49.8 60.5 44.8 59.9 74.5 100.0 131.8 76.3 161.6 92.6 120.0 1280 × 768 1280 × 768 39.6...
-
Page 19: List Of Compatible 3D Signals
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector List of compatible 3D signals The 3D signals that can be input to this projector are shown in the table below. Display mode Display Scanning Dot clock HDMI frequency resolution frequency Side by Frame Top and Side by... - Page 20 PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Display mode Display Scanning Dot clock RGB1/RGB2 HDMI RGB1 3G-SDI frequency resolution frequency & DVI & Level B (dots)* (MHz) RGB2 (kHz) (kHz) Line Frame Side Line Simul- Simul- Simul- Side sequen- taneous taneous taneous line tial side*...
-
Page 21: Serial Connector
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Serial connector The serial connector complies with RS-232C. To control the projector from a personal computer, com- mands must be input through communication software, based on the format and satisfying the commu- nication conditions shown below. Pin assignments and signal names... -
Page 22: Cable Specifications
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Cable specifications Control commands Command : Parameter Function Callback P O N Standby power on POWER (STANDBY) P O F Standby power off O S H: 0 OSH:0 Shutter off SHUTTER O S H: 1 OSH:1 Shutter on... - Page 23 PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Status request commands Command : Parameter Function Callback Description Q P W Main power status Q S H Shutter function status Q I N Input signal status DIGITAL LINK HDMI RGB 1 RGB 2 Video DL1:HD 1 HDMI 1...
- Page 24 PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Notes on projector placement and operation The projector uses a high-wattage lamp that becomes very hot during operation. Please observe the following precautions. Never place objects on top of the projector. Make sure there is an unobstructed space of 500 mm (1 feet 8 inches) or more around the projec- tor’s exhaust openings.
-
Page 25: Direction Of Air Intake And Exhaust
PT-DZ870K/DZ870W/DZ870LK/DZ870LW Projector Direction of air intake and exhaust Intake Exhaust Operating the projector continuously If the projector is to be operated continuously for one week, use the dual-lamp optical system's alternat- ing lamp operation (lamp relay) function. The projector cannot be operated continuously one week in dual-lamp mode.