Clock Phase; Geometry (Pt-Dz8700/Pt-Ds8500 Only) - Panasonic PTDZ8700U - DLP PROJECTOR Operating Instructions Manual

POSITION menu
Press ▲▼ to select [INTERLOCKED].
3 )
Press ◄► to switch [INTERLOCKED].
4 )
The [VERTICAL] and
[HORIZONTAL] settings are used
OFF
as the vertical and horizontal zoom
ratios respectively.
The zoom ratio is set to the [BOTH]
setting.
ON This allows the pictures to be
zoomed at equal vertical and
horizontal ratios.
Note
z
When [ASPECT] is set to [THROUGH], [ZOOM] will not
appear.
z
When other than [DEFAULT] is selected for [ASPECT],
the [MODE] selection setting will not appear.

CLOCK PHASE

Clock phase adjustment achieves the best image
when the screen flickers or halos are observed around
contours.
Press ▲▼ to select [CLOCK PHASE].
1 )
Press ◄► or <ENTER> button.
2 )
z
The [CLOCK PHASE] individual adjustment
screen will be displayed.
Press ◄► to adjust the level.
3 )
z
The value changes from 0 to 63. Adjust so that
the amount of interference is at a minimum.
Note
z
The CLOCK PHASE may not be adjusted, depending on
the signal.
z
No optimal value may be obtained if the output of the PC
to which the signal input is applied is unstable.
z
No optimal value may be obtained if the total number of
dots is not correct.
z
The [CLOCK PHASE] can be adjusted only when RGB
signal input is applied with RGB1 and RGB2 IN.
60
- ENGLISH
GEOMETRY
(PT-DZ8700/PT-DS8500 only)
Square video can be projected onto a special shaped
screen using unique image processing technology.
Press ▲▼ to select [GEOMETRY].
1 )
Press ◄► to switch [GEOMETRY].
2 )
z
The setting will change as follows each time
◄► is pressed.
OFF
PC
Geometry correction is not
OFF
performed.
This adjusts projected images when
KEYSTONE
they are distorted to a trapezoid.
This adjusts projected images
CURVED when they are distorted to a curved
surface.
This is for performing geometry
Û
PC
correction from a computer.
Û
: GEOMETRY adjustment should be carried out by
a person who is familiar with the projector or by
a service person because a high level of skill is
required to make successful adjustment.
3 ) Select [KEYSTONE] or [CURVED] in
Step 2), and press <ENTER> button.
z
The [GEOMETRY : KEYSTONE] or
[GEOMETRY : CURVED] screen will be
displayed.
Press ▲▼ to select the desired
4 )
adjustment item, and press ◄► to
adjust the correction amount.
z
You can adjust the projection images as shown
below.
KEYSTONE
CURVED