Paper Handling Settings - Xerox 8500DN - Phaser Color Solid Ink Printer Advanced Features Manual

Paper Handling Settings

This section includes:
■ Setting the Duration for Tray 1 Prompts
■ Changing the Load Paper Timeout
Setting the Duration for Tray 1 Prompts
The control panel Tray 1 prompt setting specifies the amount of time the prompt displays on
the control panel after paper is loaded in Tray 1. The tray setup prompt displays the current
tray setup.
Duration
None
30 Seconds
(Factory default setting)
Infinite
Note:
This setting applies only to Tray 1. The printer does not display a prompt when paper is
loaded into Trays 2, 3, or 4.
To select Tray 1 prompt settings, use one of the following options:
■ The printer's control panel
■ CentreWare IS
Using the Control Panel
To select the Tray 1 prompt setting on the control panel:
1. Paper Tray Setup, and then press the OK button.
Select
2. Select Paper Handling
3. Tray 1 Prompt, and then press the OK button.
Select
4. Select the appropriate duration, and then press the OK button.
Using CentreWare IS
To select the Tray 1 prompt setting using CentreWare IS:
1. Launch your web browser.
2. Enter the printer's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Select General on the left sidebar, and then select Printer Defaults.
5.
Select the appropriate setting in the Tray 1 Prompt drop-down list.
6. Click Save Changes at the bottom of the page.
on page 5-7
on page 5-8
Behavior
Turns the tray setup prompt off.
Displays the tray setup prompt for up to 30 seconds after paper is
loaded in Tray 1.
Displays the tray setup prompt after paper is loaded in Tray 1 until a
selection is made on the control panel.
Setup, and then press the OK button.
Phaser® 8500/8550 Color Printer
5-7
Printer Settings