Loading Paper Into The Multi-Bypass - Kyocera KM-2030 Instruction Handbook Manual

IMPORTANT
When loading 11" x 17" paper, push down the length adjustment plate
completely as shown in the illustration.
5
Set the paper flush against the left-hand wall of the drawer.
IMPORTANT
• There is a sticker (1 in the illustration) indicating paper capacity
attached to the inside of the drawer. Do not load paper above this
limit.
• When loading paper into the drawer, make sure that the copy side is
facing upward. (The copy side is the side facing upward when the
package is opened.)
• Check that the length adjustment plate makes secure contact with
the paper. If there is a gap, adjust the position of the length adjust-
ment plate.
• If small-sized paper jams frequently under high temperature and
high humidity conditions, reduce the number of sheets to the level of
the black line indicated on the sticker (1 in the illustration).
CHAPTER 3 HOW TO LOAD PAPER
6
Set the supplied paper size sheet so that the size of the
paper loaded can be checked by looking at the front of the
drawer.
7
Gently push the drawer back in.
* If you force the drawer in, paper may come out from under
the claws and paper misfeed may result.
NOTE
• Before leaving the copier in disuse for a prolonged period of time,
remove the paper from the drawer(s) and seal it in its original
packaging to protect from moisture. Also, when storing paper in a
temperature and high humidity enbironment, seal it in a moisture-
proof bag.

(3) Loading paper into the multi-bypass

Special paper as well as standard paper can be loaded into the multi-
bypass. When copying onto transparencies or thick paper, be sure to
use the multi-bypass.
NOTE
• Number of sheets of standard paper, colored paper and letterheads
that can be loaded into the multi-bypass differ depending on the
paper size.
11" x 17" and 8 1/2" x 14" (A3, B4 and Folio): 25 sheet
11" x 8 1/2" and 5 1/2" x 8 1/2" (A4 to A6R): 50 sheets
• The types of special paper and the number of sheets that can be
loaded in the multi-bypass are:
· Transparencies: 1 sheet
2
· Standard paper (120g/m , 160g/m
IMPORTANT
• When setting special paper, such as transparencies and thick paper,
into the multi-bypass, select the type of paper by referring to "
Setting the paper type and size for the multi-bypass" on page 3-3.
2
): 1 sheet
3-2