Kyocera KM-2030 Instruction Handbook Manual page 51

CHAPTER 6 COPIER MANAGEMENT
Machine default setting
0 Shut-off time
Selects a certain length of time from when the copier is not used to
when the auto shut-off function (page 4-7) switches off the power
automatically. The auto shut off function can be turned off as well. This
setting cannot be used in that case ("2 Auto shut-off").
The initial setting is 30 minutes.
• It is recommended to prolong time interval that triggers the auto shut-
off if the copier is used frequently, whereas shorten it if it is not used
frequently.
• See "2 Auto shut-off" to release the auto shut-off function.
• If the optional fax board or printer board is installed, the copier enters
the energy saver mode when the auto shut-off function is triggered.
For details, see the instruction handbook for the fax board or printer
board.
! Display contrast
Changes the display contrast when the message display is not seen
adjust. clearly.
@ Management code
Changes the management code that accesses the management mode
change (page 6-1) and management mode in this default setting (page 6-9).
• If management code is changed, keep a note of the new one.
# Silent mode
The copier can be switched to the silent mode, which stops the motor
inside the copy machine immediately after copying has been finished.
When "ON" is selected, the motor stops immediately after copying has
been finished.
$ Auto drawer
Selects whether the automatic drawer switching function (page 2-4) is
switch used or not.
% Counter report
Prints the toner counter report.
6-15
Content of machine default setting Setting range Default setting
15 to 240 min. 30 min.
(5-minute incre-
ments)
1 to 7 4 (center)
– – – – 2000
On/Off Off
On/Off On
——————— —————
Page
6-18
6-18
6-18
6-18
6-19
6-19