Cisco TELEPRESENCE VIDEO COMMUNICATION SERVER - COMMAND REFERENCE V X6 Command Reference Manual page 53

xConfiguration command reference
Zones Zone [1..1000] TraversalClient Authentication Mode:
<DoNotCheckCredentials/TreatAsAuthenticated/CheckCredentials>
Controls how the VCS authenticates incoming messages from this zone and whether they are subsequently
treated as authenticated, unauthenticated, or are rejected. The behavior varies for H.323 messages, SIP
messages that originate from a local domain and SIP messages that originate from non-local domains. See
the Administrator Guide for full details about each of the Authentication Policy options.
Default: DoNotCheckCredentials
Example: xConfiguration Zones Zone [1..1000] TraversalClient Authentication Mode:
DoNotCheckCredentials
Zones Zone [1..1000] TraversalClient Authentication Password: <S: 0,215>
The password used by the VCS when connecting to the traversal server. The maximum plaintext length is
128 characters, which is then encrypted.
Example: xConfiguration Zones Zone 1 TraversalClient Authentication Password:
"password123"
Zones Zone [1..1000] TraversalClient Authentication UserName: <S: 0,128>
The user name used by the VCS when connecting to the traversal server.
Example: xConfiguration Zones Zone 1 TraversalClient Authentication UserName:
"clientname"
Zones Zone [1..1000] TraversalClient H323 Port: <1024..65534>
Specifies the port on the traversal server to be used for H.323 firewall traversal calls from this VCS. If the
traversal server is a VCS Expressway, this must be the port number that has been configured on the VCS
Expressway's traversal server zone associated with this VCS.
Example: xConfiguration Zones Zone 4 TraversalClient H323 Port: 2777
Zones Zone [1..1000] TraversalClient H323 Protocol: <Assent/H46018>
Determines which of the two firewall traversal protocols will be used for calls to and from the traversal server.
Note: the same protocol must be set on the server for calls to and from this traversal client.
Default: Assent
Example: xConfiguration Zones Zone 4 TraversalClient H323 Protocol: Assent
Zones Zone [1..1000] TraversalClient Peer [1..6] Address: <S:0,128>
Specifies the IP address or Fully Qualified Domain Name (FQDN) of the traversal server. If the traversal
server is a VCS Expressway cluster, this will be one of the peers in that cluster.
Example: xConfiguration Zones Zone 4 TraversalClient Peer 1 Address: "10.192.168.1"
Zones Zone [1..1000] TraversalClient Registrations: <Allow/Deny>
Controls whether proxied SIP registrations routed through this zone are accepted.
Default: Allow
Example: xConfiguration Zones Zone 4 TraversalClient Registrations: Allow
Zones Zone [1..1000] TraversalClient RetryInterval: <1..65534>
Specifies the interval (in seconds) with which a failed attempt to establish a connection to the traversal server
should be retried.
Default: 120
Example: xConfiguration Zones Zone 4 TraversalClient RetryInterval: 120
Cisco VCS Command Reference (X6) Page 53 of 95