Cisco TELEPRESENCE VIDEO COMMUNICATION SERVER - COMMAND REFERENCE V X6 Command Reference Manual page 37

xConfiguration command reference
Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call to or from an endpoint in the Default Subzone (applies
only if the mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Limit:
1920
Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in the Default
Subzone.
NoBandwidth: no bandwidth available. No calls can be made to or from the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Mode:
Limited
Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within the Default Subzone
(applies only if the mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Limit:
1920
Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within the
Default Subzone.
NoBandwidth: no bandwidth available. No calls can be made within the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Mode:
Limited
Zones LocalZone DefaultSubZone Bandwidth Total Limit: <1..100000000>
Sets the total bandwidth limit (in kbps) of the Default Subzone (applies only if Mode is set to Limited).
Default: 500000
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth Total Limit: 500000
Zones LocalZone DefaultSubZone Bandwidth Total Mode: <Limited/Unlimited/NoBandwidth>
Determines whether the Default Subzone has a limit on the total bandwidth being used by its endpoints at
any one time.
NoBandwidth: no bandwidth available. No calls can be made to, from, or within the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth Total Mode: Limited
Zones LocalZone DefaultSubZone Registrations: <Allow/Deny>
Controls whether registrations assigned to the Default Subzone are accepted.
Default: Allow
Example: xConfiguration Zones LocalZone DefaultSubZone Registrations: Allow
Cisco VCS Command Reference (X6) Page 37 of 95