Cisco TELEPRESENCE VIDEO COMMUNICATION SERVER - COMMAND REFERENCE V X6 Command Reference Manual page 5

xConfiguration command reference
Administration HTTP Mode: <On/Off>
Determines whether HTTP calls will be redirected to the HTTPS port.
On: calls will be redirected to HTTPS.
Off: no HTTP access will be available.
Note: you must restart the system for any changes to take effect.
Default: On
Example: xConfiguration Administration HTTP Mode: On
Administration HTTPS Mode: <On/Off>
Determines whether the VCS can be accessed via the web interface. This must be On to enable both web
interface and TMS access.
Note: you must restart the system for any changes to take effect.
Default: On
Example: xConfiguration Administration HTTPS Mode: On
Administration HTTPS RequireClientCertificate: <On/Off>
Determines whether the VCS requires a valid client certificate from your web browser before setting up an
HTTPS session. Note: this does not affect client verification of the VCS's server certificate.
Default: Off
Example: xConfiguration Administration HTTPS RequireClientCertificate: On
Administration LCDPanel Mode: <On/Off>
Controls whether the LCD panel on the front of the VCS identifies the system.
On: the system name and first active IP address are shown.
Off: the LCD panel reveals no identifying information about the system.
Default: On
Example: xConfiguration Administration LCDPanel Mode: On
Administration SSH Mode: <On/Off>
Determines whether the VCS can be accessed via SSH and SCP.
Note: you must restart the system for any changes to take effect.
Default: On
Example: xConfiguration Administration SSH Mode: On
Administration Telnet Mode: <On/Off>
Determines whether the VCS can be accessed via Telnet.
Note: you must restart the system for any changes to take effect.
Default: Off
Example: xConfiguration Administration Telnet Mode: Off
Administration TimeOut: <0..10000>
Sets the number of minutes that an administration session (HTTPS, Telnet or SSH) may be inactive before
the session is timed out. A value of 0 turns session time outs off.
Default: 0
Example: xConfiguration Administration TimeOut: 0
Cisco VCS Command Reference (X6) Page 5 of 95