Cisco TELEPRESENCE VIDEO COMMUNICATION SERVER - COMMAND REFERENCE V X6 Command Reference Manual page 52

xConfiguration command reference
Zones Zone [1..1000] Neighbor SIP TLS Verify Mode: <On/Off>
Controls X.509 certificate checking and mutual authentication for inbound and outbound connections
between this VCS and the neighbor system. When enabled, the neighbor system's FQDN or IP address, as
specified in the Peer address field, must be contained within the neighbor's X.509 certificate (in either the
Subject Common Name or the Subject Alternative Name attributes).
Default: Off
Example: xConfiguration Zones Zone 3 Neighbor SIP TLS Verify Mode: On
Zones Zone [1..1000] Neighbor SIP Transport: <UDP/TCP/TLS>
Determines which transport type will be used for SIP calls to and from this neighbor.
Default: TLS
Example: xConfiguration Zones Zone 3 Neighbor SIP Transport: TLS
Zones Zone [1..1000] Neighbor SIP UDP BFCP Filter Mode: <On/Off>
Determines whether INVITE requests sent to this zone filter out UDP/BFCP. This option may be required to
enable interoperability with SIP devices that do not support the UDP/BFCP protocol.
On: any media line referring to the UDP/BFCP protocol is replaced with TCP/BFCP and disabled.
Off: INVITE requests are not modified.
Default: Off
Example: xConfiguration Zones Zone 1 Neighbor SIP UDP BFCP Filter Mode: Off
Zones Zone [1..1000] Neighbor SIP UPDATE Strip Mode: <On/Off>
Determines whether or not the VCS will strip the UPDATE method from the Allow header of all requests and
responses going to and from this zone.
Default: Off
Example: xConfiguration Zones Zone 3 Neighbor SIP UPDATE Strip Mode: Off
Zones Zone [1..1000] Neighbor ZoneProfile: <Default/Custom/MicrosoftOCS2007/
CiscoUnifiedCommunicationsManager/NortelCS1000/AdvancedMediaGateway/NonRegisteringDevice>
Determines the way in which the advanced settings for this zone are configured.
Default: uses the factory defaults for thesesettings.
Custom: allows you to configure each setting individually.
Preconfigured profiles: alternatively, choose one of the preconfigured profiles to automatically use the
appropriate settings required for connections to that type of system.
Default: Default
Example: Zones Zone 3 Neighbor ZoneProfile: Default
Zones Zone [1..1000] SIP Mode: <On/Off>
Determines whether SIP calls will be allowed to and from this zone.
Default: On
Example: xConfiguration Zones Zone 3 SIP Mode: On
Cisco VCS Command Reference (X6) Page 52 of 95