Xconfiguration Command Reference; Xconfiguration Commands - Cisco TELEPRESENCE VIDEO COMMUNICATION SERVER - COMMAND REFERENCE V X6 Command Reference Manual

xConfiguration command reference

The xConfiguration group of commands are used to set and change individual items of
configuration. Each command is made up of a main element followed by one or more sub-elements.
The following section lists all the currently available xConfiguration commands.
To set a particular item of configuration, type the command as shown. The valid values for each
command are indicated in the angle brackets following each command, using the following notation:
Format Meaning
<0..63> Indicates an integer value is required. The numbers indicate the minimum and
maximum value.
In this example the value must be in the range 0 to 63.
<S: 7,15> An S indicates a string value, to be enclosed in quotation marks, is required. The
numbers indicate the minimum and maximum number of characters for the string.
In this example the string must be between 7 and 15 characters long.
<Off/Direct/Indirect> Lists the set of valid values for the command. Do not enclose the value in quotation
marks
[1..50] Square brackets indicate that you can configure more than one of this particular item.
Each item is assigned an index within the range shown.
For example IP Route [1..50] Address <S: 0,39> means that up to 50 IP routes
can be specified with each route requiring an address of up to 39 characters in length.
To obtain information about existing configuration, type:
xConfiguration to return all current configuration settings
n
xConfiguration <element> to return all current configuration for that particular element and all its
n
sub-elements
xConfiguration <element> <subelement>to return all current configuration for that group of
n
sub-elements
To obtain information about using each of the xConfiguration commands, type:
xConfiguration ? to return a list of all elements available under the xConfigurationcommand
n
xConfiguration ?? to return a list of all elements available under the
n
xConfigurationcommand, along with the valuespace, description and default values for each
element
xConfiguration <element> ? to return all available sub-elements and their valuespace,
n
description and default values
xConfiguration <element> <sub-element> ? to return all available sub-elements and their
n
valuespace, description and default values

xConfiguration commands

All of the available xConfiguration commands are listed in the table below:
Cisco VCS Command Reference (X6)
xConfiguration command reference
Page 4 of 95