Xerox 1235/DX - Phaser Color Laser Printer Advanced Features And Troubleshooting Manual page 79

Front Panel Menus, Items and Values (cont'd.)
Menu Description and Items
Token IPP Enable
Ring
(cont)
IP Address
Res
IP Address
Sub Net Mask
Default
Gateway
Port Timeout
Source
Routing
Speed
LAA
Advanced Features and Troubleshooting Manual
Enables or disables the Token Ring IPP protocol. Available values
are:
On*
Off
Sets the method used to assign the IP address, including Sub Net
mask and Default Gateway. Available values are:
Static
BOOTP/RARP
DHCP*
Sets the 4 byte IP address. Available values are:
xxx.xxx.xxx.xxx
(where xxx = 000 to 255)
See the section Setting Network Addressing on page 48 for an
explanation of how to set this item.
Sets the 4 byte Sub Net Mask address. Available values are:
xxx.xxx.xxx.xxx
(where xxx = 000 to 255)
Note
See the section
page 48 for an explanation of how to set this item.
Sets the 4 byte Default Gateway address. Available values are:
xxx.xxx.xxx.xxx
(where xxx = 000 to 255)
See the section Setting Network Addressing on page 48 for an
explanation of how to set this item.
Sets the time for determining when to terminate an incomplete
print job and poll the next port in the polling sequence. Available
values are:
5 - 300 seconds (60 seconds*)
Sets the source routing option. Available values are:
Off*
All
Single/All
Single/Specific
Sets the default ring speed of the Token Ring interface. Available
values are:
4
16*
Sets the 6 byte Locally Administered Address. Valid values are:
xxxx xxxx xxxx
(where xxxx xxxx xxxx can equal any value
within the valid range of 4000 0000 0000 and
7FFF FFFF FFFF)
Managing Printer Usage
Setting Network Addressing
on
63