Xerox 1235/DX - Phaser Color Laser Printer Advanced Features And Troubleshooting Manual page 109

Printer Management Status Messages (cont'd.)
Message
Jn-Toner Empty
[J9-Yellow Toner Empty]
[J10-Magenta Toner
Empty]
[J11-Cyan Toner Empty]
[J12-Black Toner Empty]
Load Tray #, Size Type
T1-Fuser Upper Error
T2-Fuser Lower Error
T29-Temp Sensor Error
T30-RH Sensor Error
T31-Roller Over Error
T32-LED Over Temp Error
Advanced Features and Troubleshooting Manual
Type Explanation/Corrective Action
Fault The toner cartridge has reached its end of life.
Install a new toner cartridge.
Fault The specified paper size and type requested by the
print job is not available in the specified tray.
Load the specified paper or press Enter to print
anyway from the tray.
Fault A short fault in the upper fuser Thermistor was
discovered. Turn off the printer, wait 15 seconds,
then turn on the printer. If the problem persists,
install a new fuser. For further assistance, visit the
support links at
www.xerox.com/officeprinting/1235support.
Fault A short fault in the lower fuser Thermistor was
discovered. Turn off the printer, wait 15 seconds,
then turn on the printer. If the problem persists,
install a new fuser. For further assistance, visit the
support links at
www.xerox.com/officeprinting/1235support.
Fault The temperature sensor is either not
communicating or reporting invalid data. To reset
the sensor, open and close the top cover. If the
problem persists, check the support links at
www.xerox.com/officeprinting/1235support.
Fault The relative humidity sensor is either not
communicating or reporting invalid data. Turn off
the printer, wait 15 seconds, then turn on the
printer. If the problem persists, check the support
links at
www.xerox.com/officeprinting/1235support.
Fault The fuser temperature sensor is reporting a
temperature error. Turn off the printer, wait 15
seconds, then turn on the printer. If the problem
persists, install a new fuser. For further assistance,
visit the support links at
www.xerox.com/officeprinting/1235support.
Fault One of the LED bars is reporting a temperature
error. Turn off the printer, wait 15 seconds, then
turn on the printer. If the problem persists, check
the support links at
www.xerox.com/officeprinting/1235support.
Troubleshooting
93