Xerox 1235/DX - Phaser Color Laser Printer Advanced Features And Troubleshooting Manual page 104

Troubleshooting
Front Panel Messages (cont'd.)
Message
Supply Fan Error U9
Power Off/On
Temp Sensor Error T29
Power Off/On
Toner Empty
[Black Toner Empty]
[Cyan Toner Empty]
[Magenta Toner Empty]
[Yellow Toner Empty]
Replace Toner
Toner Low
Black Toner Low
Cyan Toner Low
Magenta Toner Low
Yellow Toner Low
Toner Missing
[Black Toner Missing
[Cyan Toner Missing
[Magenta Toner Missing
[Yellow Toner Missing
Reseat Toner
Top Cover A Open
Close Top Cover A
Top Output Bin Full Remove
Prints
Transfer Belt Missing
Reseat Belt
88
Type Explanation/Corrective Action
Fault An error has been detected with the power
supply cooling fan. Turn off the printer, wait
15 seconds, then turn on the printer. If the
problem persists, check the support links at
www.xerox.com/officeprinting/1235support.
Fault The temperature sensor is either not
communicating or reporting invalid data.
Turn off the printer, wait 15 seconds, then
turn on the printer. If the problem persists,
check the support links at
www.xerox.com/officeprinting/1235support.
Fault The toner cartridge has reached its end of
life. Install a new toner cartridge.
Attention The level of toner in the toner cartridge is
low and should be replaced soon, as it is near
its end of life. Printing can continue until the
toner cartridge is empty; however, some
degradation of image quality may occur. The
message remains until interrupted by other
messages or until the toner cartridge is
replaced.
Fault The toner is either missing or requires
reseating to be recognized by the printer.
Reseat the toner. If that does not fix the
problem, turn off the printer, wait 15
seconds, then turn on the printer. If the
problem persists, check the support links at
www.xerox.com/officeprinting/1235support.
Fault The top cover (Cover A) is open. Close the
cover so that printing can continue.
Fault The top (face-down) bin is full and cannot
accept any more prints until it is emptied.
Once emptied, printing will continue where
it left off.
Fault The transfer belt is either missing or requires
reseating to be recognized by the printer.
Turn off the printer, make sure the transfer
belt is properly installed and turn on the
printer. If the problem persists, install a new
transfer belt. For further assistance, visit the
support links at
www.xerox.com/officeprinting/1235support.
Phaser 1235 Network Color Printers