Xerox 1235/DX - Phaser Color Laser Printer Advanced Features And Troubleshooting Manual page 102

Troubleshooting
Front Panel Messages (cont'd.)
Message
Jam A7, Remove Prints
Open Cover A, See Labels
Jam B13
Open Area B, See Labels
Jam B21
Open Cover B, See Labels
Jam B8
Open Cover B, See Labels
LED Error
[Black LED Error U21]
[Cyan LED Error U20]
[Magenta LED Error U19]
[Yellow LED Error U18]
Power Off/On
LED Over Temperature T32
Power Off/On
Load Tray #
Size Type
Power Supply Error U6
Power Off/On
86
Type Explanation/Corrective Action
Fault Paper did not enter the duplex module
properly, causing a paper jam. Open Cover A
and refer to the labels on the printer to clear
the jam. For more information, see the
Solving Printing Problems
sections
<RefInTable>(page 98)
Fault Paper did not exit the duplex module
correctly, causing a paper jam. Open Area B
and refer to the labels on the printer to clear
the jam. For more information, see the
Solving Printing Problems
sections
<RefInTable>(page 98)
Fault Paper did not exit the transport area
correctly, causing a paper jam. Open Cover B
and refer to the labels on the printer to clear
the jam. For more information, see the
Solving Printing Problems
sections
<RefInTable>(page 98)
Fault Paper did not enter the duplex module
properly, causing a paper jam. Open Cover B
and refer to the labels on the printer to clear
the jam. For more information, see the
Solving Printing Problems
sections
<RefInTable>(page 98)
Fault The LED bar is either missing or requires
reseating to be recognized by the printer.
Turn off the printer, wait 15 seconds, then
turn on the printer. If the problem persists,
check the support links at
www.xerox.com/officeprinting/1235support.
Fault One of the LED bars is reporting a
temperature error. Turn off the printer, wait
15 seconds, then turn on the printer. If the
problem persists, check the support links at
www.xerox.com/officeprinting/1235support.
Fault The specified paper size and type requested
by the print job is not available in the
specified tray. Load the specified paper or
press Enter to print from the tray anyway.
Fault During the printer's self diagnostics it was
detected that the power supply voltage is out
of specification. Turn off the printer, wait 15
seconds, then turn on the printer. If the
problem persists, check the support links at
www.xerox.com/officeprinting/1235support.
Phaser 1235 Network Color Printers
.
.
.
.