Network Functions; Led Functions; Network Factory Default Setting (For Hl-5070N) - Brother HL 5030 - B/W Laser Printer Service Manual

CHAPTER 2 INSTALLATION AND BASIC OPERATION
6.

NETWORK FUNCTIONS

6.1

LED functions

No light:
If both of the two LEDs are off, then the print server is not connected to the network.
Link/Speed LED is orange: Fast Ethernet
Link/Speed LED is green: 10 Base T Ethernet
This Link/Speed LED will be orange if the print server is connected to a 100BaseTX Fast
Ethernet network.
This Link/Speed LED will be green if the print server is connected to a 10 Base T Ethernet.
Active LED is yellow:
The Active LED will blink if the print server is receiving or transmitting data.
6.2

Network Factory default setting (For HL-5070N)

If you wish to reset the print server back to its default settings (resetting all information such
as the password and IP address information), please follow these steps;
(1) Turn off the printer.
(2) Make sure that the front cover is closed and the power cord is plugged in.
(3) Hold down the Go button as you turn on the power switch. All the LEDs will light up. Keep
the Go button pressed down until all the LEDs except for Toner LED go off. When the
Drum, Paper and Status LEDs go off, release the Go button.
(4) Hold down the Go button and keep it pressed down until the yellow Status LED comes on.
When the Status LED comes on, release the Go button.
(5) When all the LEDs light up again, the printer will start warming up. The print server has
been reset to its default factory settings.
NOTE:
*If you wish to reset the printer and automatically disable the APIPA protocol, follow steps 1 to
4 above, however, hold down the Go button until the Status LED is green, not yellow.
*For more information on APIPA, see the Network User's Guide or visit
http://solutions.brother.com
Fig. 2-48
2-36
Link/Speed LED
Active LED