Control Panel Button Operations - Brother HL 5030 - B/W Laser Printer Service Manual

CHAPTER 2 INSTALLATION AND BASIC OPERATION
Table 1: LED indications after pressing Go and Job Cancel
LEDs
Toner
Drum
Paper
Status
5.4

Control Panel Button Operations

The control panel button is used for the following purposes depending on the situation.
Operation
Cancel printing
Wake-up
Form feed
Error recovery
Reprint
Fixing
Laser unit
unit
failure
failure
Description
If you press the Job Cancel button while printing, the printer will
immediately stop printing and will then eject the paper.
If the printer is in Sleep mode, press the Go or Job Cancel button to wake
the printer up and go to the Ready state.
If the yellow Status LED is on, press the Go button. The printer will print
any data that is left in the printer memory.
If there is an error, the printer will recover automatically from some errors.
If an error is not automatically cleared, press the Go button to clear the
error, and then continue to use the printer.
If you want to reprint a document that has just been printed, you can do
this by pressing and holding down the Go button until all four LEDs are lit
and then release the Go button.
Main
Main PCB
motor
failure
failure
2-32
Engine
DIMM
PCB
failure
failure