Brother HL 5030 - B/W Laser Printer Service Manual page 47

CHAPTER 2 INSTALLATION AND BASIC OPERATION
(3) Pull out the MP tray support flap.
(4) When loading paper in the MP tray, make sure it touches the back of the tray and remains
under the maximum paper height guides on both sides of the tray.
NOTE:
Note the following when placing paper on the multi-purpose tray:
•
If the paper to be printed on weighs more than 105 g/m
tray.
•
Insert the leading edge of the paper first and push it gently into the tray.
•
If pre-printed paper is used in the multi-purpose tray, the paper should be inserted top
edge first with the printed side face up.
•
Make sure that the paper is straight and in the proper position on the MP tray. If it is not,
the paper may not be fed properly, resulting in a skewed printout or a paper jam.
(5) While pressing the paper-guide release lever, slide the paper guide to fit the paper
size.
NOTE:
*The side to be printed on must be face up.
*During printing, the inside tray rises to feed paper into the printer.
(6) Send the print data to the printer.
Fig. 2-16
2-16
2
(28 lbs), use the face up output