Brother HL 5030 - B/W Laser Printer Service Manual page 129

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
(10) Remove the two pan (washer) M2.6x6 Taptite screws.
(11) Remove the heat roller 25.
(12) Remove the halogen lamp.
Screw, pan (washer)
M2.6x6
FU frame upper
NOTE:
When re-assembling the halogen heater lamp, ensure that the direction of the halogen heater
lamp is correct referring to the figure above.
!
CAUTION:
• Never touch the surface of the halogen heater lamp.
• When securing the screw to assemble the halogen lamp connector plate, ensure you use
the plastic jig as shown in the figure below to avoid damaging the edge of the halogen
heater lamp.
Heat roller 25
Halogen lamp
Halogen lamp connector plate
Halogen heater lamp
Heat roller 25
Fig. 4-55
Screw, pan (washer) M2.6x6
Fig. 4-56
4-32
Halogen lamp
Screw, pan (washer)
M2.6x6
Colored side
115V:Orange
230V:Black
Halogen lamp
connector plate
Plastic jig