Brother HL 5030 - B/W Laser Printer Service Manual page 226

CHAPTER 6 TROUBLESHOOTING
P-2 Unable to print full pages of a document with the "PRINT OVERRUN" message.
User Check
(1) Press the Go switch on the control panel to print the data remaining in the printer.
(2) If this does not clear the error, reduce the complexity of your document or reduce the printer
resolution.
(3) Expand the printer memory by adding a commercially available DIMM. (except for HL-5030)
(4) Change the following setting in the printer driver and try again. The best combination of settings
below will vary depending on your document.
Graphic Mode / TrueType
(except for HL-5030)
NOTE:
This problem may appear if the data is too complex. If it is not cleared by taking the actions
above, it will be impossible to print such data under the printer specifications.
P-3 Unable to print full pages of a document with the "MEMORY FULL" message.
User Check
(1) Press the Go switch on the control panel to print the data remaining in the printer.
(2) Reduce the complexity of your document or reduce the printer resolution.
(3) Expand the printer memory by adding a commercially available DIMM. (except for HL-5030)
NOTE:
This problem may appear if the data is too complex.
Possible cause
Unable to
recognize DIMM
DIMM / main
PCB failure
TM
mode (except for HL-5030) / Use Printer TrueType
Step Check
1 Check the memory size in
Print Configuration. Is it the
default size?
2 Try installing DIMM into
another printer, then check the
memory size in Print Settings.
Is it possible to print the data?
Result
Yes Expand the memory size by
adding DIMM.
If the memory is already at the
maximum size, it will be
impossible to print the data
under the printer
specifications.
Yes Replace the main PCB.
No Replace the DIMM.
6-46
TM
Fonts
Remedy