Brother HL 5030 - B/W Laser Printer Service Manual page 56

(3) Remove the printed even-numbered pages from the output tray and put them in the same
order back into the manual feed tray. Place the paper with the side that is going to be printed
on (the blank side) face up. Follow the instructions on the computer screen.
(4) Repeat Step 3 until you have printed all the odd-numbered pages on the other side of the
paper.
Manual duplex printing from the MP tray (For HL5050 and HL-5070N)
!
CAUTION:
*Before putting the sheets back in the MP tray, you will have to straighten them, or you may
get paper jams.
*You should not use very thin or very thick paper.
*When you use the manual duplex function, it is possible that there may be paper jams or
poor print quality. If there is a paper jam, see 4. PAPER PROBLEMS in Chapter 6.
(1) Choose the Manual Duplex printing mode from the Advanced tab, and from the Basic tab
select the Paper Source to be MP Tray feed.
(2) Using both hands put the paper in the MP tray with the side to be printed on first facing up.
Follow the instructions on the computer screen. Repeat this step until you have printed all
the even-numbered pages.
(3) Remove the printed even-numbered pages from the output tray and put them in the same
order back into the MP tray. Place the paper with the side that is going to be printed on (the
blank side) face up. Follow the instructions on the computer screen.
HL-5030/5040/5050/5070N SERVICE MANUAL
Fig.2-30
Fig.2-31
2-25