Battery Inspection; Battery Removal And Installation; Charging; Remote Controller - Eton ATV RXL 50 Service Manual

12.4 BATTERY INSPECTION

Battery is under the seat, you can see this battery from the
left side.
Measure the battery voltage using a voltmeter.
VOLTAGE: Fully charged: 13.1 V
Undercharged: Below 12.0 V
BATTERY REMOVAL
Remove the battery holder bolt nuts.
Disconnect the negative cable and then
the position cable and remove the battery.
BATTERY INSTALLATION
Install the battery in the reverse order of removal.
After installing the battery, coat the terminals with
clean grease.

12.5 CHARGING

Connect the charge positive cable to the battery position
terminal.
Connect the charge negative cable to the battery negative
terminal.
Using 0.9A-charging current about 5 hours. (Normal charging)
Or using 4A-charging current about 1 hour. (Quick charging)
Keep flames and sparks away from a battery being charged.
Quick charging should be limited to an emergency;
Normal charging is preferred.
11.4 REMTOTE CONTROLLER
If the remote controller was lost and faulty or its cells empty. You must change cells or buy a
new one and follow the steps below to make the controller function correctly. It is also
application in ATV that has remote controller.
57