Ignition Coil (Atv Rxl 50/90 And Kxl 90 And Mxl 50 All Have The Same Model In This Chapter); Ignition Timing; Alternator Exciter Coil; Battery Caution - Eton ATV RXL 50 Service Manual

12.2 IGNITION COIL
(ATV RXL 50/90 and KXL 90 and MXL 50 all have the same model in this chapter)
Remove the spark plug cap from the spark plug.
Disconnect the ignition coil primary wire.
Measure the primary coil resistance.
STANDARD: 0.1 - 0.3Ω(20℃)
Measure the secondary coil resistance with
the spark plug cap in place.
STANDARD : 7.4 – 12 kΩ(20℃)

IGNITION TIMING

The ignition advance is 15°± 3°/4000rpm
The Capacitive Discharge Ignition (CDI) system is factory pre-set and does not require adjustment.

ALTERNATOR EXCITER COIL

Remove the seat / rear fender and front fender. (see chapter 10)
Disconnect the exciter coil wire.
Measure the resistance between the yellow / red wire and ground.
STANDER : 460-700Ω (AT 20℃, 68℉)

12.3 BATTERY CAUTION

The battery gives off explosive gases; keep sparks, flames and cigarettes away. Provide adequate
ventilation when charging or using the battery in an open area. The battery contains sulfuric acid
(electrolyte). Contact with skin or eyes may cause severe burns. Wear protective clothing and a face shield.
Electrolyte is poisonous. If swallowed drink large quantities of water or milk and call a physician.
56