3. ENGINE REMOVAL AND INSTALLATION
3.1 SERVICE INFORMATION
3.2 ENGINE REMOVAL
3.1 ENGINE SHALL BE REMOVED IN THE CONDITIONS OF NECESSARY REPAIRMENT OR
ADJUSTMENT TO THE TRANSMISSION AND COMBUSTION SYSTEM ONLY
3.2 ENGINE REMOVAL
Remove the seat and rear fender. (Chapter 11)
Remove the spark plug cap from the spark plug.
Remove the exhaust pipe.
Disconnect the carburetor cable by unscrew two screws
on top of the carburetor.
Take off oil pump cable from the oil pump control plate.
Oil pump is under the right side of engine.
Disconnect the wire connectors. There are three
connectors for carburetor auto-choke, starter motor
and generator respectively.
Remove the drive chain cover. This is under the chain.
Remove the drive chain retaining clip and master link,
and remove the drive chain.
Remove the three engine hanger nuts and bolts.
Remove the engine from the right side of frame.
(The pictures of right side are for ATV RXL 50 / 70 / 90
and RXL 50M)
3.3 ENGINE INSTALLATION
12