Front Wheel; Front Brake Inspection - Eton ATV RXL 50 Service Manual

9.2 TROUBLESHOOTING
FRONT WHEEL WOBBLING
BRAKE DRAG
POOR BRAKE PERFORMANCE

9.3 FRONT WHEEL

REMOVAL
Raise the front wheels off the ground by placing a block
under the frame.
Remove the front wheel nuts, washer and wheels.
INSTALLATION
Install and tighten the four-wheel castle nuts
Torque: 40-60 N.m
Remember put a cotter pin in the castle nut.
9.4 FRONT BRAKES

FRONT BRAKE INSPECTION

Remove the front wheel.
Remove the brake drum.
(In this section, because of ATV RXL 50M has no front brake. So it is only for ATV RXL 50 / 70 / 90 and RXL
90R.)
Measure the brake lining thickness.
The minimum limit: 1.5 mm
If they are thinner than the minimum limit,
replace the brake linings.
★ FAULTY TIRE
★ WORN FRONT BRAKE DRUM BEARING
★ BENT RIM
★ AXLE NUT NOT TIGHTENED PROPERLY
★ INCORRECT BRAKE ADJUSTMENT
★ STICKING BRAKE CABLE
★ BRAKE SHOES WORN
★ WORN BRAKE DRUM
★ BRAKE LININGS OILY, GREASY OR DIRTY
★ IMPROPER BRAKE ADJUSTMENT
39