Install the rear brake lever bracket, aligning the boss
with the hole.
Tighten the screw securely.
(The picture of right side is for ATV RXL 50/90
and RXL 90R)
Aligning the split line of the throttle housing
and holder with the punch mark.
Tighten the screw securely
(The picture of right side is for ATV RXL 50/90
and RXL 90R)
(The picture of right side is for ATV RXL 50M)
8.4 STEERING SYSTEM (The ATV RXL and KXL and MXL have the same system)
REMOVAL OF KINGPIN AND TIE-ROD
Remove the front wheels and brakes plates.
Remove the four self-lock nuts from the tie-rod
ball joints and take off the two tie-rods.
33