Toe-In; Gear Oil - Eton ATV RXL 50 Service Manual

2.13 TOE-IN

Let the vehicle on level ground and the front wheels
facing straight ahead.
Mark the centers of the tires to indicate the axle
center height.
Measure the distance between the marks.
Carefully move the vehicle back, let the wheels have
turned 180 °, so the marks on the tires are aligned
with the axle center height.
Measure the distance between the marks.
Calculate the difference in the front and rear
measurements.
Toe-in: 5±10mm
If the toe-in is out of standard, adjust it by changing
the length of the tie-rods equally by turning the tie-rod
while holding the ball joint.
Tighten the lock nuts.
Torque: 35-43 N.m

2.14 GEAR OIL

Gear oil needs to be changed every year.
There is a gear oil release bolt at the rear of engine.
Unscrew this release bolt and can let the dirty oil flow out.
The re-add oil hole is on the engine case beside gearbox.
(CAUTION: Only the ATV RXL 90R must add the reverse oil)
11