Advertisement

Advertisement

Table of Contents
loading

Summary of Contents for Eton EXL-50

  • Page 1: Table Of Contents

    TABLE OF CONTENTS TABLE OF CONTENTS YOUR RESPONSIBILITIES YOUR RESPONSIBILITIES (for Viper ) (for Yukon ) CONTROL FEATURES CONTROL FEATURES ENGINE CONTROLS Start Button THROTTLE LEVER THROTTLE LEVER BRAKE CONTROLS BRAKE CONTROLS FUEL SYSTEM FUEL SYSTEM Fuel Tank Fuel Tank Fuel Valve Fuel Valve Inline Fuel Filter...
  • Page 2 TABLE OF CONTENTS TABLE OF CONTENTS BRAKING SYSTEMS BRAKING SYSTEMS Front Brake System Inspection Front Brake Adjustment Rear Brake System Inspection To Fill The Reservoir Purging Brake Lines ELECTRICAL BATTERY ELECTRICAL BATTERY THROTTLE LEVER THROTTLE LEVER Adjusting The Throttle Cable DRIVE CHAIN DRIVE CHAIN Chain Slack Adjustment...
  • Page 3: Your Responsibilities

    WELCOME Thank you for purchasing an E-TON But safety depends on you - your driving all-terrain vehicle. We hope you enjoy ability, your common sense, and your safe ridinging. care in maintaining your ATV. The safety tips, riding hints, and ATV maintenance E-TON ATV'S are designed for safety, information are Included in this manual.
  • Page 4 Vehicle Identification Numbers Vehicle Identification Number (VIN) Engine serial number is located at the front of the unit under is located on the left-hand side of the the front fender on a plate mounted engine on the crankcase housing. between the main frame rails. Your VIN Eng.
  • Page 5 Controls, Switches & Feature Locations(for Viper Locations of controls and features (1) Fuel tank cap (6) Speedometer & odometer (2) Front brake lever/parking brake Direction indicator lamp (3) Throttle lever Headlight lamp (4) Reverse indicator lamp Fuel indicator meter Neutral indicator lamp (7) Main switch Forward indicator lamp (8) Transmission gear selector...
  • Page 6 Controls, Switches & Feature Locations(for Yukon Locations of controls and features (5) Rear brake lever (1) Fuel tank cap (6) Speedometer & odometer (2) Front brake lever /parking brake (7) Direction indicator lamp (3) Throttle lever Headlight lamp (4) Reverse indicator lamp Fuel indicator meter Neutral indicator lamp (8) Main switch...
  • Page 7: Control Features

    CONTROL FEATURES CONTROL FEATURES Engine controls THROTTLE LEVER The throttle lever is located on the right-hand handle bar below the grip. To operate the START BUTTON Your E-TON ATV has an electric start. The start button is on the left handlebar. Press the button until engine starts.
  • Page 8: Brake Controls

    CONTROL FEATURES CONTROL FEATURES Parking Brake Front and Rear Brakes This vehicle is equipped with dual front mechanical drum brakes and a rear hydraulic disc brake. The front brakes are controlled by the long brake lever on the right-handle bar. The rear brake is controlled by the long lever on the left-handle bar.
  • Page 9: Fuel System

    CONTROL FEATURES CONTROL FEATURES Fuel System NEVER REFUEL YOUR ATV when the engine is HOT. Wait 30 minutes after turning off the unit before refueling. Spilling fuel on a Fuel Tank HOT engine could cause a fire. Wipe up any fuel spills before re-starting.
  • Page 10: Tires And Wheels

    CONTROL FEATURES CONTROL FEATURES Tires and Wheels Fuel Line Tire & Wheel inspection Vacumn Control Line Inline Fule Filter Inline Fule Filter The filter should be replaced every 600 hours of operation and at the start of each season. To replace the filter, carefully compress the wire clamp rings until the clamp is free of the It is important to inspect your tires and wheels fuel line.
  • Page 11: Fuel Indicator Meter

    FUEL INDICATOR METER SPEEDOMETER & ODOMETER 1.The main power control switch turns the It is digital LCD meter and displayed in cold power on and off. light can applicable to night. 2.Fuel indicator to"F"when the tank is full, (1)Speedometer digital follow ATV's speed and to"E"when empty.(The theoil gauge to change digital.
  • Page 12: Reverse Indicator Lamp

    Transmission Gear selector When shifting gears it is important that you Bring the vehicle to a complete stop with the rear brake fully engaged and the enqine at idle. If you attempt to shift the transmission with the engine running above the idle speed the engine will automatically shut down to protect the transmission.
  • Page 13: Specifications

    SPECIFICATIONS SPECIFICATIONS Viper Yukon Engine Type Two cycle air cooled Two cycle air cooled Displacement 49.3cc 49.3cc Bore / Stroke 50.0 * 42.0mm 50.0 * 42.0mm 7.9:1 7.9:1 Compression 7ps @ 7500rpm 7ps @ 7500rpm Power Transmission Type Automatic (C.V.T. V-Belt) Automatic (C.V.T.
  • Page 14 SPECIFICATIONS SPECIFICATIONS Viper Yukon Sprockets 19 teeth 19 teeth Frnot 34 teeth 34 teeth Rear Chain #520 #520 Battery 12V-4AH/5AH- GTX5L 12V-4AH/5AH- GTX5L Fluids Type Unleaded Gasoline 92 octane Unleaded Gasoline 92 octane Fuel Volume 4.5 liters / 1.2 gal 4.5 liters / 1.2 gal High grade synthetic 2 cycle High grade synthetic 2 cycle...
  • Page 15: Engiee Oil

    Engine Oil Check the oil tank level manually during every other refueling operation. Oil Tank The oil tank capacity is 1.1 liters, 1.2qt. Fill the tank with high quality JASO FC grade 2 cycle engine oil. Using lower grade oil can cause exhaust smoke and result in damage to your engine.
  • Page 16: Air Filter

    Air Filter C.V.T. Filter This unit is equipped with an air filter for the C.V.T. transmission. It is located on the left- hand side of the engine, just ahead of the kick starter spindle. The filter will accumulate dust Air Filter Maintenance To maintain the highest performance from your engine and to reduce excessive wear that could cause engine failure the engine requires a...
  • Page 17: Braking Systems

    Braking Systems operation. Tighten, repair or replace parts as needed to insure safe brake operation. Clean any build-up of mud or debris from the brake Your ATV unit is equip ped with dual front mechanism. mechanical drum brakes and a rear hydraulic disc brake.
  • Page 18: Rear Brake System Inspection

    To Fill the Reservoir Rear Brake System Inspection Remove the reservoir cover by removing the two Visually inspect the brake hose for any signs of cover bolts. wear or leaks. Check the fluid level in the fluid reservoir by checking the site glass for the level. Brake Fluid Resivour Site Glass Fill the reservoir to 1/8"...
  • Page 19: Purging Brake Lines

    Electrical Battery Purging Brake Lines Yukon Viper The unit's battery is located under the seat and For the hydraulic brake system to operate safely, supplies electrical power to the unit. The battery the brake system must be purged of air in the lines is a 12 volt jell acid type that contains no liquid and reservoir.
  • Page 20: Throttle Lever

    Throttle Lever maximum speed of the unit. Turning the stop screw counter clockwise will increase the throttle The throttle lever is located beside the right- travel thus increasing the maximum speed of the handlebar grip and is operated by using the right- unit.
  • Page 21: Drive Chain

    The chain should be kept well lubricated to Drive Chain prevent excess wear and premature failure. We recommend that you lubricate the chain every 15 hours of operation, or more frequently if needed, with a high quality chain lubricant. 10-20mm 0.39"-0.79"...
  • Page 22 Maintenance Schedule Replace Fuel & Vent Lines every 2 years Inspect as part of pre-ride inspection I, L Inspect as part of pre-ride inspection Inspect as part of pre-ride inspection Replace every 2 years Inspect as part of pre-ride inspection Inspect as part of pre-ride inspection...
  • Page 23: Break-In Your New Daelim Atv

    INSPECTION Before you ride, know your ATV. Make sure you are familiar with all controls and their operation. Check the ATV's condition before (and after) every ride. It only takes a few minutes and could save your life. Check fuel level. Check brake operation.
  • Page 24 THE BASICS - START SLOW. USE CAUTION Select a safe area with a level surface that is Free of obstacles. Normally, touching your feet to the ground for balance is not necessary. To increase engine speed, gradually open the throttle. When you park, park on a level surface.
  • Page 25 RIDING IN REVERSE To shift into reverse: Make sure the ATV is completely stopped, and the transmission is in neutral. Check for obstacles or people behind you. Squeeze the rear brake level. Push the gearshift bar to backward position. Open the throttle gradually. When stopping in reverse gear, carefully apply both the front and rear brakes.
  • Page 26 Page 26...
  • Page 28 ETON AMERICA, LLC. LIMITED VEHICLE WARRANTY ETON America warrants all new ETON vehicles sold by authorized Eton Dealers to be free from defects in materials and workmanship, subject to the following exclusions and limitations. New vehicles sold by an authorized dealer to original retail consumers are covered by this policy for a period of six (6) months from the date of delivery.
  • Page 29 "set-up and pre-delivery checklist" prior to delivery to the customer. This warranty is valid at any authorized ETON Dealer in the United States only. In the event you experience any problem obtaining prompt service, contact ETON America, customer service department for assistance.
  • Page 30: Memo

    Owner's Notes: Page 30...
  • Page 31 Page 31...
  • Page 32 Page 32 Page 31...

This manual is also suitable for:

Viper stYukon st

Table of Contents