Digital Pen; Diskette Drive (External) - Gateway C-140S Reference Manual

Digital pen

The convertible notebook does not respond to the digital
pen
•
The pen tip does not line up with the pointer when you tap
the screen
•

Diskette drive (external)

The diskette drive is not recognized
•
You see an "Access Denied" or "Write protect" error
message
•
•
•
•
You see a "Disk is full" error message
•
•
•
118
CHAPTER 9: Troubleshooting
You are not using the correct pen. Use only digitizer
pens sold by Gateway for your convertible notebook.
The convertible notebook does not respond to other
tablet pens or plastic pens.
The digital pen and display need recalibrating in both
Landscape and Portrait mode. For instructions on
recalibrating your digital pen, see "Using Tablet PC" in
the online User Guide.
Shut down and restart your convertible notebook.
Move the write-protection tab in the upper-right corner
of the diskette down (unprotected).
The diskette may be full. Delete unnecessary files on the
diskette and try again.
Not all diskettes are IBM-compatible. Make sure that the
diskette you are using is IBM-compatible.
Try a different diskette. Occasionally diskettes are
flawed and cannot be read by the diskette drive.
Delete unnecessary files on the diskette.
Try a different diskette. Occasionally diskettes are
flawed and cannot be read by the diskette drive.
Run Error checking on the diskette. If errors are
detected and corrected, try using the diskette again. For
instructions on running Error checking, see "Checking
the hard drive for errors" in your online User Guide.