Installing The Power Supply; Dc Power In Male Connector Configuration; Figure 33. Installing The Power Supply; Figure 34. Dc Power In Male Connector Configuration - Intel TIGI2U - Carrier Grade Server User Manual

Platform Installations and Upgrades

Installing the Power Supply

1. When inserting the new power supply, make sure the green handle is depressed
downward while sliding the module into the power supply cage.
2. Install the chassis cover. For instructions, see

DC Power In Male Connector Configuration

Please use the following instructions when installing or replacing a DC power supply.
1. Slide open top of male connector to reveal screw holes (see letter "A" in Figure 34).
2. Strip wire insulation as shown. Note minimum wire gauge (see letter "B" in Figure 34).
3. Insert each wire all the way and tighten to 24 in-lb (2.7 N-m) torque (see letter "C" in
Figure 34).
56

Figure 33. Installing the Power Supply

Figure 34. DC Power In Male Connector Configuration

"Installing the Chassis Cover."
®
Intel Carrier Grade Server TIGI2U User Guide