Common Linux Problems - Muratec F-112P User Manual

Common Linux Problems

Problem
The machine doesn't print
Possible Cause and Solution
• Check if the printer driver is installed in your system.
Open MFP configurator and switch to the Printers tab
in Printers configuration window to look at the list of
available printers. Make sure that your machine is
displayed on the list. If not, please, invoke Add new
printer wizard to set up your device.
• Check if the printer is started. Open Printers
configuration and select your machine on the printers
list. Look at the description in the Selected printer
pane. If its status contains "(stopped)" string, please,
press the Start button. After that normal operation of
the printer should be restored. The "stopped" status
might be activated when some problems in printing
occurred. For instance, this could be an attempt to
print document when MFP port is claimed by a
scanning application.
• Check if the MFP port is not busy. Since functional
components of MFP (printer and scanner) share the
same I/O interface (MFP port), the situation of
simultaneous access of different "consumer"
application to the same MFP port is possible. To avoid
possible conflicts, only one of them at a time is
allowed to gain control over the device. The other
"consumer" will encounter "device busy" response.
You should open MFP ports configuration and select
the port assigned to your printer. In the Selected port
pane you can see if the port is occupied by some other
application. If this is the case, you should wait for
completion of the current job or should press Release
port button, if you are sure that the present owner is
not functioning properly.
• Check if your application has special print option such
as "-oraw". If "-oraw" is specified in the command line
parameter then remove it to print properly. For Gimp
front-end, select "print" -> "Setup printer" and edit
command line parameter in the command item.
T 9.23
ROUBLESHOOTING
9