Using The Remote Control - Dish Network Solo 351 User Manual

What's Happening
When you run Check Switch, you see
"Twin" identified as the Device/LNBF but
you only have signal confirmed from one
satellite.
When you run Check Switch, you see
"Twin" identified as a Device or LNBF, but
only odd transponders are detected.
Getting receiver messages that signal is lost
or being acquired
* Compatible accessory devices must pass 2150 MHz signals, 22 KHz signals both directions (per DiSEqC 2.0
specifications), and pass DC power.

Using the Remote Control

What Is Happening
You cannot find the remote control.
When you press a button on the remote
control, the receiver does not do what you
expect.
When you press the remote control Power
button to turn the receiver ON, the receiver
front panel Power light does not light up.
What's Wrong
• The DISH Pro Twin LNBF is connected
but the dish may not be pointed to
receive signal from both 110 and 119
satellites.
• Cables may not be rated for 2150 MHz.
• Check the weather conditions to see if
heavy rain or snow could be temporarily
block the signal.
• Check for any obstructions in way of the
dish like new growth on trees
Possible Reason
• N/A
• The remote control may be missing
batteries, the batteries may be
incorrectly placed in the remote, or the
batteries may be weak or dead.
• You may be using the wrong remote
control (1 or 2) for the menus (TV1 or
TV2) you are trying to operate.
• Other lights are too bright.
• Remote control not operating properly
or the batteries are weak or dead.
The receiver power cord not plugged
into a power outlet, or there may be a
problem with the power.
• The remote control(s) may not be set to
the address(es) used by the satellite
receiver.
• You may be using the wrong remote
control (1 or 2) for the menus (TV1 or
TV2) you are trying to operate.
Troubleshooting Tables
What You Can Do
• If the check switch summary screen
shows "119 W" on Dish Input 2, you
need to point you dish 9 degrees to the
east and repeak your dish. Rerun check
switch.
• If the check switch summary screen
shows "110 W" on Dish Input 1, you
need to point you dish 9 degrees to the
west and repeak your dish. Rerun check
switch.
• Make sure skew setting is correct for a
Dish 500 installation at your zip code.
Rerun check switch.
• Make sure cable is rated for 2150 MHz
and all accessory devices are
compatible. Rerun check switch.
• Wait for weather to clear up and restore
signal.
• Clear obstructions from the signal path.
What to Do
• Use the receiver front panel Control
Buttons to control the receiver until
you find the remote. If the remote
control is permanently lost or too
damaged to use, call the Service Center
to order a replacement.
• If the batteries are missing or dead,
insert fresh AAA-size batteries.
If the remote has fresh batteries, check
whether they are placed according to the
label diagram. If not, remove them and
place correctly.
• Make sure you are using Remote
Control 1 (2) to control TV1 (TV2)
menus.
• Try other remote control buttons to see
if the receiver is responding.
• Replace the remote batteries with fresh
ones.
• Check that the receiver power cord is
not damaged, and that the plug is
inserted correctly into the outlet.
• Make sure the remote control(s) are set
to the same address(es) used by the
satellite receiver. See page 32 for
information on changing the remote
control address.
• Make sure you are using Remote
Control 1 (2) to control TV1 (TV2)
menus.
Page 105