c. Press the POUND (#) button. If you entered the address correctly,
the SAT mode button will flash three times.
d. Press the RECORD button.
e. Make sure the
Remote Address
matches the number you entered in step b.
Setting Up TV1 to Operate in IR
The following instructions describe how to set up TV1 to operate in IR only.
1. Perform the following with an existing remote control:
a. Open the
TV1 UHF Pro Setup
the remote control.
b. Select
Disable
c. Select
System Info
2. Using an IR remote control, such as a Remote Control 3.0, that you
intend to use to control TV1:
a. Press the RECORD button. The
highlighted.
b. Make sure the
Remote Address
screen shows that the
System Information
shows
UHF Pro and IR
screen by pressing MENU-6-1-8 on
from the
TV1 UHF Pro Setup
to open the
System Information
Done
screen shows that the
System Information
shows
.
IR
Setting Up TV1 to Operate in IR
Primary
and that this address
screen.
screen.
button should be
Primary
Page 35