Connecting The Receiver To The Phone Line - Dish Network Solo 351 User Manual

4. For , select either
TV2 Out
(for cable channel numbers).
5. Highlight the number under
6. Use the UP and DOWN ARROW buttons to change the modulator
channel to one of the following:
• - Select a channel between
Air Mode
•
Cable Mode
7. Select to save the changes.
Done
8. Change the channel on your TV(s) to match the channel(s) you selected.
9. If desired to remind you of which TV channel to tune to get satellite
programming, place a channel sticker near or on your TV to indicate the
correct channel.
10. If you changed your TV2 Out channel, repeat Programming the
Recover Button for a Remote TV.

Connecting the Receiver to the Phone Line

You must keep the receiver connected to an active telephone line.
Otherwise, you may not be able to order pay per view programs or use all of
the DISH Interactive features.
: You may be able to use a wireless telephone extender. However, this
Note
may not support all the features of this receiver, such as Caller ID.
: If you have a Digital Subscriber Line (DSL), you may have to install
Note
a DSL filter between the receiver's back panel PHONE JACK and the
telephone wall jack to successfully connect with the DISH Network. You
can obtain a filter from your DSL provider.
Phone Line Connection
Run a telephone cable with a standard RJ-11 connector from the receiver's
back panel Phone Jack to an active telephone connection.
Phone System Setup
You must also set up the receiver for your telephone system (touchtone or
rotary/pulse), and set a telephone number prefix, if you need a prefix to
make an outside call.
1. Display the
Phone System
Connecting the Receiver to the Phone Line
(for off-air channel numbers) or
Air
.
TV2 Out
- Select a channel between
screen by pressing MENU-6-1-4.
Cable
and .
21 69
and .
73 125
Tip: The channel
stickers are located
inside the front
cover of this guide.
Page 27