Setting Up Tv1 To Operate In Uhf Pro - Dish Network Solo 351 User Manual

Chapter 2
Receiver Description and Installation

Setting Up TV1 to Operate in UHF Pro

Page 34
3. Put the UHF antenna onto the attenuator.
You can set your receiver to operate your TV1 using another UHF Pro
remote control (sold separately) by completing the following instructions:
If you set up your DISH 322 to operate the side using UHF Pro,
the two UHF Pro remotes for this receiver will interfere with
each other when operated at the same time. This may prevent
the remotes from operating the receiver momentarily.
1. Perform the following using an existing remote control:
a. Open the
TV1 UHF Pro Setup
the remote control.
b. Select from the
Enable
c. Select
System Info
d. Move the highlight to the address for the
as shown below. This is important - if you do not do this, your
remote will change the receiver's
cause your Remote Control 1 to control the
2. Perform the following using the UHF Pro remote that you are going to
use to control TV1:
a. Press and hold the SAT mode button about three seconds, until all
the mode buttons light up, and then let go of the SAT button. The
SAT mode button will blink.
b. Use the NUMBER PAD buttons to enter any number from 1 to 16,
except for the number shown by the
The SAT mode button goes out after you enter each digit, and then
lights up again.
Write down the number you entered:
screen by pressing MENU-6-1-8 on
TV1 UHF Pro Setup
to open the
System Information
Primary Remote Address
Secondary Remote Address
Note: Highlight the
Primary Remote
Address.
Secondary Remote Address
screen.
screen.
and
side of your receiver.
.