ScanSoft OMNIPAGE PRO 14 Manual page 60

zone (provided it stays rectangular) to discard unneeded columns or rows
from the outer edges of a table.
The five grouped table handling tools on the Imaging toolbar can be used
if the current page contains a table type zone. If the tool you need is not
visible, click the triangle on the bottom right of the visible tool to display
all the tools, then click the desired one.
Use the table tools and their cursors as follows:
Insert row dividers
Click the tool then click at the location in a table zone where you want to
place a row divider. Avoid placing a divider so it cuts through text.
Insert column dividers
Click the tool then click at the location in a table zone where you want to
place a column divider.
Move dividers
Click the tool and move the cursor to the row or column divider to be
moved. It displays a double-headed arrow. Drag the divider as desired.
You cannot drag it beyond its neighbor. Avoid placing dividers so they
cut through text.
Remove dividers
Click the tool then click on a single row or column divider you want to
delete. Do this if a divider is wrongly located, or if you want to change
the appearance of the table in the final document. For example, you can
place two columns of data in a single column by deleting the divider
between the columns.
Place/Remove all dividers
Click this tool and click its cursor icon inside a table zone without
dividers. Dividers will be auto-detected and placed. Click it in a table
with dividers to make them all disappear.
Press the Ctrl key as you click if you want to place, move or delete a
divider in the current cell only.
You can specify line formatting for table borders and grids from a
shortcut menu. You will have greater choice for editing borders and
shading in the Text Editor after recognition.
60 Processing documents