ScanSoft OMNIPAGE PRO 14 Manual page 15

By default OmniPage Pro uses its own scanning interface, located
in the Scanner panel of the Options dialog box. If you want to
use your scanner's own interface instead, choose Advanced
settings and select this. Choose Modify hints only if you are
experienced in configuring scanners or have been advised by
Technical Support to do so.
Click Next to start the tests. For the Basic scan test, insert a test
page into your scanner. The wizard will scan using your scanner
manufacturer's software. Click on Next. Your scanner's native
user-interface will appear.
Click on Scan to begin the sample scan.
If necessary, click on Missing Image... or Improper
Orientation... and make the appropriate selections.
Once the image appears correctly in the window, click on Next.
Move through the remaining requested tests, following the
instructions on the screen.
When all the requested tests have been completed successfully,
the Scanner Wizard reports and invites you to click on Finish.
You have successfully configured your scanner to work with
OmniPage Pro 14!
To change the scanner settings at a later time, or to setup or remove a
scanner, reopen the Scanner Setup Wizard from the Windows Start menu
or from the Scanner panel of the Options dialog box.
To test and repair an improperly functioning scanner, open the wizard
and select 'Test the current scanner or digital camera' in the second panel,
then work through the procedure described above, maybe using advice
received from Technical Support.
To specify a different default scanner, open the wizard to reach the list of
setup scanners. Move the highlight to the desired scanner and be sure to
close the wizard with Finish.
To get updated settings for your current scanner, open the wizard, request
a fresh database download in the first screen, then choose 'Use current
settings with current device', click Next and then Finish.
Setting up your scanner with OmniPage Pro
Chapter 1
15