Scanning And Recognition; System Hang During Scan; System Hang During Auto Form Design - NUANCE OMNIFORM 2 Reference

Scanning and Recognition

System Hang During Scan

System Hang During Auto Form Design

This section describes common scanning and recognition problems and
possible solutions:
• System Hang During Scan
• System Hang During Auto Form Design
• Scanner Compatibility
A system hang during a scan could have several possible causes:
• An interrupt conflict between your scanner and another device
such as a bus mouse or network card.
Check interrupt addresses for a possible conflict. See your device
documentation.
• A SCSI termination problem.
Make sure the scanner is terminated properly. See your scanner
documentation.
• A memory-related problem.
Try closing open windows and applications to free up memory.
System hangs may be related to incompatibilities with memory-resident
applications or device drivers. Use a text editor to comment out any
memory-resident device drivers and applications from your
autoexec.bat and config.sys file not used by Windows, DOS,
OmniForm, your scanner, or your hard drive, and then restart your
system.
Do not remove a device driver unless you are aware of its function and
know that it may be removed safely.
Hard disks often require special device drivers that should not be
removed. Video displays that require special device drivers may need to
be reconfigured instead of removed.
Make a backup disk with your current operating system version,
autoexec.bat, and config.sys to guard against potential mistakes.
Consult your device documentation for more information.
Scanning and Recognition
Technical Information - 260