Lamp Command; Cf_Lamph Command; Cf_Lampmode Command - Sanyo PDG-DSU30 - 2500 Specifications

PDG-DSU30 Expand Serial Command Functional Specifications
8.8

Lamp Command

8.8.1

CF_LAMPH Command

Command "CF_LAMPH_%1"[CR]
%1 "RST"-----------------Reset Lamp counter.
Reset total lamp running time
Details
This command is available in normal Power ON status.
Acceptable
Correspondence
Unacceptable
8.8.2

CF_LAMPMODE Command

Command "CF_LAMPMODE_%1" [CR]
"ON" ---------------------------- Set ECO mode On
%1
"OFF" -------------------------- Set ECO mode Off
Select Eco mode. (Valid only when in the normal Power ON status.)
The value set by this command is stored in EEPROM and the setting value
Details
No display is shown when projector received command..
Acceptable
Correspondence
Unacceptable
"000" [CR]
"Error Code" [CR]
remains after the power is ALL OFF.
"000" [CR]
"Error Code" [CR]
22 / 42