Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - CONFIGURING DSMS REV 1 Manual page 64

58 E M
NTERASYS ATRIX
N-S
ERIES
For example, enter the command below if you wish to enable a syslog server
configuration for the following:
• Index — 1
IP address: 134.141.89.113
•
Facility: local4
•
• Severity: Level 3 on port 514
set logging server 1 ip-addr 134.141.89.113 facility local4
severity 3 port 514 state enable
For more information on configuring the Matrix N-Series, consult your vendor
documentation.
You are now ready to configure the sensor device within the STRM interface. To
configure STRM to receive events from an Enterasys Matrix N-Series device,
choose one of the following options:
If you are using STRM 6.0, select Enterasys N Series Switch/Router from the
•
Sensor Device Type drop-down list box.
If you are using STRM 6.0.1 and above, select Enterasys N Series Switch
•
from the Sensor Device Type drop-down list box.
For information on configuring sensor devices, see the Managing Sensor Devices
Guide.
Configuring DSMs Guide