Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - CONFIGURING DSMS REV 1 Manual page 11

2 3C
A STRM 3Com 8800 Series Switch DSM accepts events using syslog. STRM
records all relevant status and network condition events. Before configuring a
3Com 8800 Series Switch device in STRM, you must configure your device to
send syslog events to STRM.
To configure the device to send syslog events to STRM:
Log in to the 3Com 8800 Series Switch interface.
Step 1
Enable the information center.
Step 2
info-center enable
Configure the host with the IP address of your STRM system as the loghost, the
Step 3
severity level threshold value as informational, and the output language to English.
info-center loghost <ip_address> facility <severity> language
english
Where:
<ip_address>
<severity>
Configure the ARP and IP information modules to log.
Step 4
info-center source arp channel loghost log level informational
info-center source ip channel loghost log level informational
You are now ready to configure the sensor device within the STRM interface. To
configure STRM to receive events from a 3Com 8800 Series Switch, you must
select the 3Com 8800 Series Switch option from the Sensor Device Type
drop-down list box. For more information on configuring sensor devices, see the
Managing Sensor Devices Guide.
8800 S
OM
is the IP address of your STRM system.
is the facility severity.
Configuring DSMs Guide
S
ERIES WITCH