Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - CONFIGURING DSMS REV 1 Manual page 100

94 J NSM
UNIPER
Configuring
Juniper NSM
Protocol
Step 1
Step 2
To configure STRM to integrate with a Juniper NSM device:
Configure the Juniper NSM protocol in the STRM interface.
To configure STRM to receive events from a Juniper NSM device using Juniper
NSM protocol, you must select the JuniperNSM option from the Protocol
drop-down list box when configuring your protocol configuration. For more
information, see Configuring Protocols in the Managing Sensor Devices Guide.
Note: In the STRM interface, the JuniperNSM protocol configuration enables you
to use the Juniper NSM IP address by selecting the Use NSM Address for Event
Source check box. If you wish to change the configuration to use the originating IP
address (clear the check box), you must log in to STRM, as root, and restart IP
tables using the following command:
Configure the sensor device within the STRM interface.
To configure STRM to receive events from a Juniper NSM device, you must select
the Juniper Networks NetScreen-Security Manager (NSM) option from the
Sensor Device Type drop-down list box. For more information on configuring
devices, see the Managing Sensor Devices Guide.
Configuring DSMs Guide
service restart iptables