Installing And Removing The Sfp Modules - Cisco ASA5500-HW - Hardware Accessory Kit Network Device Hardware Installation Manual

Installing and Removing the SFP Modules

To remove the SFP module, perform the following steps:
Disconnect all cables from the SFP.
Step 1
Warning Because invisible laser radiation may be emitted from the aperture of the port when no cable is
connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 70
Do not pull on the cabling in an attempt to remove the SFP.
Caution
Disconnect your particular SFP latch, as shown in
Step 2
Figure 4-19
A
B
1 Mylar tab
3 Bale-clasp
Step 3 Grasp the SFP on both sides, and remove it from the port.
Cisco ASA 5500-X Series Hardware Installation Guide
4-16
Disconnecting SFP Latch Mechanisms
1 2
2 Actuator/Button
4 Plastic collar
Chapter 4
Figure 4-19.
3 4
Maintenance and Upgrade Procedures