Cisco ASA5500-HW - Hardware Accessory Kit Network Device Hardware Installation Manual page 10

48 VDC Power System
Warning The customer 48 volt power system must provide reinforced insulation between the primary AC power
and the 48 VDC output. Statement 128
Multiple Power Cord
Warning This unit has more than one power cord. To reduce the risk of electric shock when servicing a unit,
disconnect the power cord of the power strip that the unit is plugged into. Statement 137
Circuit Breaker (15A) Warning
Warning This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 10A international) is used on the
phase conductors (all current-carrying conductors). Statement 13
Grounded Equipment Warning
This equipment is intended to be grounded. Ensure that the host is connected to earth ground during
Warning
normal use. Statement 39
Safety Cover Requirement
The safety cover is an integral part of the product. Do not operate the unit without the safety cover
Warning
installed. Operating the unit without the cover in place will invalidate the safety approvals and pose
a risk of fire and electrical hazards. Statement 117
Faceplates and Cover Panel Requirement
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place. Statement
142
Cisco ASA 5500-X Series Hardware Installation Guide
x
About This Guide