TP-Link JetStream TL-SG3216 User Manual page 181

The following entries are displayed on this screen:
Create Notification
IP Address:
UDP Port:
User:
Security Model:
Security Level:
Type:
Retry:
Timeout:
Notification Table
Figure 12-8 Notification Config
Enter the IP Address of the management Host.
Enter the number of the UDP port used to send notifications.
The UDP port functions with the IP address for the notification
sending. The default is 162.
Enter the User name of the management station.
Select the Security Model of the management station.
Select the Security Level for the SNMP v3 User.
•
noAuthNoPriv: No authentication and no privacy security
level are used.
•
authNoPriv: Only the authentication security level is used.
•
authPriv: Both the authentication and the privacy security
levels are used.
Select the type for the notifications.
•
Trap: Indicates traps are sent.
•
Inform: Indicates informs are sent. The Inform type has a
higher security than the Trap type.
Specify the amount of times the switch resends an inform
request. The switch will resend the inform request if it doesn't
get the response from the management station during the
Timeout interval, and it will terminate resending the inform
request if the resending times reach the specified Retry times.
Specify the maximum time for the switch to wait for the
response from the management station before resending a
request.
174