TP-Link JetStream TL-SG3216 User Manual page 170

Primary IP:
Secondary IP:
Authentication Port:
Authentication KEY:
Accounting Config
Accounting:
Primary IP:
Secondary IP:
Accounting Port:
Accounting Key:
Note:
1. The 802.1X function takes effect only when it is enabled globally on the switch and for the port.
2. The 802.1X function can not be enabled for LAG member ports. That is, the port with 802.1X
function enabled can not be added to the LAG.
3. The 802.1X function should not be enabled for the port connected to the authentication server.
In addition, the authentication parameters of the switch and the authentication server should
be the same.
Configuration Procedure:
Step Operation
1 Connect an authentication
server to the switch and do
some configuration.
2 Install the 802.1X
software.
3 Configure the
globally.
4 Configure the parameters of
the authentication server
5 Configure the 802.1X for the
port.
Enter the IP address of the authentication server.
Enter the IP address of the alternate authentication server.
Set the UDP port of authentication server(s). The default port is 1812
Set the shared password for the switch and the authentication
servers to exchange messages.
Enable/Disable the accounting feature.
Enter the IP address of the accounting server.
Enter the IP address of the alternate accounting server.
Set the UDP port of accounting server(s). The default port is 1813.
Set the shared password for the switch and the accounting
servers to exchange messages.
Description
Required. Record the information of the client in the LAN to
the authentication server and configure the corresponding
authentication username and password for the client.
client Required. For the client computers, you are required to
install the 802.1X software TpSupplicant provided on the
CD. For the installation guide, please refer to
802.1X Client
802.1X Required. By default, the global 802.1X function is disabled.
On the Network Security→802.1X→Global Config page,
configure the 802.1X function globally.
Required. On the Network Security→802.1X→Radius
Server page, configure the parameters of the server.
Required.
Config page, configure the 802.1X feature for the port of
the switch based on the actual network.
163
Software.
On the Network Security→802.1X→Port
Appendix D:
Return to CONTENTS