Selecting Peer Clusters For The Resource - Novell BUSINESS CONTINUITY CLUSTERING 1.1 SP2 - ADMINISTRATION Administration Manual

To add resource script search-and-replace values specific to this resource:
1 In the Resource Replacement Script section of the page, click New.
If a resource has already been configured for business continuity, you can click Edit to change
existing search-and-replace values or click Delete to delete them.
2 Add the desired search-and-replace values, then click OK.
The search-and-replace values you specify here apply to only to the resource you are enabling
for business continuity. If you want the search-and-replace values to apply to any or all cluster
resources, add them to the entire cluster instead of just to a specific resource.
See "Adding Search-and-Replace Values to the Resource Replacement Script" on page 74
more information on resource script search-and-replace values and adding those values to the
entire cluster.
3 Do one of the following:
If this is an existing cluster resource, continue with
for the Resource
If you are creating a new cluster resource, click Next, then continue with

Selecting Peer Clusters for the Resource

You can select the Use Regular Expressions check box to use wildcard characters in your search-
and-replace values. The following links provide information on regular expressions and wildcard
characters:
Regular Expressions (http://www.opengroup.org/onlinepubs/007908799/xbd/re.html)
Regular-Expressions.info (http://www.regular-expressions.info/)
Wikipedia (http://en.wikipedia.org/wiki/Regular_expression)
oreilly.com (http://www.oreilly.com/catalog/regex/)
You can find additional information on regular expressions and wildcard characters by searching the
Web.
IMPORTANT: If you change the resource-specific search-and-replace data after initially adding it,
you must update the resource load or unload scripts in one of the other clusters by editing it and
adding a space or a comment. This causes the script to be updated with the new search-and-replace
data.
You could also update the IP address on the cluster protocols page in iManager to cause IP address
search-and-replace values to be updated for both load and unload scripts. This might require you to
go back and change the IP addresses specified in the resource load and unload scripts in the source
cluster to their original values.
6.3.3 Selecting Peer Clusters for the Resource
Peer clusters are the other clusters that this cluster resource can be migrated to. The cluster or
clusters that you select determine where the resource can be manually migrated. If you decide to
migrate this resource to another cluster, you must migrate it to one of the clusters that has been
selected.
1 Select the other clusters that this resource can be migrated to.
80 BCC 1.1 SP2: Administration Guide for NetWare 6.5 SP8
section below.
section.
Step 1 in the Selecting Peer Clusters
Step 1
for
in the