Novell BUSINESS CONTINUITY CLUSTERING 1.1 SP2 - ADMINISTRATION Administration Manual page 62

5 On the Identity Manager node in the cluster, upgrade Identity Manager from version 2.x to
3.51.
For information, see
ampxjxi.html)
5a Before you begin, make sure that the Identity Manager node meets the 3.5.1 upgrade
requirements.
5b Upgrade Identity Manager from version 2.x to 3.51.
IMPORTANT: Do not start the drivers yet.
The upgrade updates the Identity Manager software and its plug-ins for iManager 2.7.2 on
the same node.
5c Stop Tomcat 5 by issuing
5d Reset Apache 2 by using the
5e Start Tomcat 5 by using the
5f Wait at least 5 minutes for the iManager changes to take effect, then restart iManager.
5g In iManager, verify that Identity Manager is available.
IMPORTANT: In iManager, the Identity Manager plug-ins are displayed as version 3.6.
The 3.6 version functions properly with Identity Manager 3.5.1.
6 Issue the
7 Issue the
8 Repeat
9 Verify that Novell Cluster Services and Business Continuity Clustering appear to be
functioning correctly by migrating a BCC enabled resource between peer clusters.
10 Create the new BCC driver sets for Identity Manager.
11 On the Identity Manager node in every peer cluster, create the new Identity Manager drivers
with the new BCC 1.1 SP2 templates.
IMPORTANT: Do not create a new partition when creating the driver set.
As a guide, you can use the information from
the BCC Cluster from 1.0 to 1.1 SP1," on page
12 Start the new Identity Manager drivers for each peer cluster.
13 Verify that Novell Cluster Services and BCC 1.1 SP2 appear to be functioning correctly by
performing the following tests:
13a Create a new BCC enabled pool resource, BCC migrate it between peer clusters, and
verify that it migrates correctly.
13b Make a load script change (for example, add a space character and save the change) to an
existing BCC resource that was created with 1.0, allow the revised load script to
synchronize, then verify that the load script was updated at all eDirectory locations.
13c BCC migrate the pool resource that you modified in
verify that it migrates correctly and that the Identity Manager drivers are synchronizing.
13d Check all SAN scripts ensure that they will perform the desired functions.
62 BCC 1.1 SP2: Administration Guide for NetWare 6.5 SP8
"Upgrading" (http://www.novell.com/documentation/idm35/install/data/
in the Identity Manager 3.5.1 Installation Guide.
tc5stop
command on each node in the cluster.
cluster join
command on each node to have them join the BCC.
ldbcc.ncf
Step 3 through Step 7 for each peer cluster.
command.
command.
ap2webrs
command.
tomcat
Step 1 and Step 5b
58.
Step 13b
in Section 5.3.1, "Upgrading
between peer clusters, and