Novell BUSINESS CONTINUITY CLUSTERING 1.1 SP2 - ADMINISTRATION Administration Manual page 42

configuration information between the Identity Manager nodes in peer clusters. To download the
Bundle Edition, go to to the
download.novell.com/Download?buildid=hEOxV3rys2M~).
Credential for Drivers
The Bundle Edition requires a credential that allows you to use drivers beyond an evaluation period.
The credential can be found in the BCC license. In the Identity Manager interface in iManager, enter
the credential for each driver that you create for BCC. You must also enter the credential for the
matching driver that is installed in a peer cluster. You can enter the credential, or put the credential in
a file that you point to.
Identity Manager Engine and eDirectory Driver
BCC requires Identity Manager 3.5.1 or later to run on one node in each of the clusters that belong to
the business continuity cluster. (Identity Manager was formerly called DirXML
should not be set up as clustered resource.
For information about installing and configuring Identity Manager 3.5.1, see the
3.5.1 documentation Web site
The node where the Identity Manager engine and the eDirectory driver are installed must have an
eDirectory full replica with at least read/write access to all eDirectory objects that will be
synchronized between clusters. This does not apply to all eDirectory objects in the tree. For
information about the eDirectory full replica requirements, see
8.8," on page
Identity Manager Driver for eDirectory
On the same node where you install the Identity Manager engine, install the following:
Single Tree: One instance of the Identity Manager driver for eDirectory.
Two Trees: Two instances of the Identity Manager driver for eDirectory. The eDirectory driver
must be installed twice on each node—once for Tree A and once for Tree B.
For information about installing the Identity Manager driver for eDirectory, see
3.5.1 Driver for eDirectory: Implementation Guide (http://www.novell.com/documentation/
idm35drivers/edirectory/data/bktitle.html).
Identity Manager Management Utilities
The Identity Manager management utilities must be installed on the same server as Novell
iManager. The Identity Manager utilities and iManager can be installed on a cluster node, but
installing them on a non-cluster node is the recommended configuration. For information about
iManager requirements for BCC, see
IMPORTANT: Identity Manager plug-ins for iManager require that eDirectory is running and
working properly in the tree. If the plug-in does not appear in iManager, make sure that the
eDirectory daemon (
To restart
ndsd
prompt as the
42 BCC 1.1 SP2: Administration Guide for NetWare 6.5 SP8
Identity Manager 3.5.1 Bundle Edition download site (http://
(http://www.novell.com/documentation/idm35/).
40.
Section 4.1.8, "Novell iManager 2.7.2," on page
) is running on the server that contains the eDirectory master replica.
ndsd
on the master replica server, enter the following command at its terminal console
user:
root
®
.) Identity Manager
Identity Manager
Section 4.1.5, "Novell eDirectory
Identity Manager
43.